To configure FXO port on a Cisco router, you will need to use the following commands:
1. Enter global configuration mode on the router: “conf t”
2. Create a controller for the FXO port: “controller t1 [slot/port]”
3. Configure the controller: “framing [type]”, “linecode [type]”, “clock source [type]”
4. Create a dial-peer for the FXO port: “dial-peer voice [number] pots”
5. Configure the dial-peer: “destination-pattern [pattern]”, “port [slot/port]”.
Q1. How do I enable an FXO port on a Cisco router?
A1. To enable an FXO port on a Cisco router, you will need to first enter global configuration mode on the router using the command “conf t”.
Then, you will need to create a controller for the FXO port using the command “controller t1 [slot/port]” and configure the controller using the commands “framing [type]”, “linecode [type]”, and “clock source [type]”.
Finally, you will need to create a dial-peer for the FXO port using the command “dial-peer voice [number] pots” and configure the dial-peer using the commands “destination-pattern [pattern]” and “port [slot/port]”.
Q2. How do I connect an FXO port to a Cisco router?
A2. To connect an FXO port to a Cisco router, you will need to connect the FXO port to the router using an appropriate cable.
Then, you will need to use the commands outlined in the answer to the previous question to configure the FXO port.
